Get Latest Final Year ECE/EEE Projects in your Email

Your Email ID:
FYP.in Subs

Coordinated Control Strategies for a Permanent Magnet Synchronous Generator based Wind Energy Conversion System

ABSTRACT

In this paper, a novel co-ordinated hybrid maximum power point tracking (MPPT)-pitch angle based on a radial basis function network (RBFN) is proposed for a variable speed variable pitch wind turbine. The proposed controller is used to maximize Continue reading

Engineering Influenza A/WSN/33 for In vivo Bioluminescent Imaging

ABSTRACT

Influenza A virus is a major causative agent of respiratory diseases in humans. It causes significant morbidity, mortality and economic losses each year worldwide with about 3-5 million clinical infections per annum. Its ability to mutate rapidly leads to seasonal Continue reading

Design, Analysis, and Verification of Ka-Band Pattern Reconfigurable Patch Antenna Using RF MEMS Switches

ABSTRACT

This paper proposes a radiating pattern reconfigurable antenna by employing RF Micro-electromechanical Systems (RF MEMS) switches. The antenna has a low profile and small size of 4 mm × 5 mm × 0.4 mm, and mainly consists of one main patch, Continue reading

Vertical-Strip-Fed Broadband Circularly Polarized Dielectric Resonator Antenna

ABSTRACT

A vertical-strip-fed dielectric resonator antenna exhibiting broadband circular polarization characteristics is presented. A broad 3 dB axial ratio bandwidth (ARBW) is achieved by combining multiple orthogonal modes due to the use of a special-shaped Continue reading

Innate Immune Evasion Mediated by Flaviviridae Non-Structural Proteins

ABSTRACT

Flaviviridae-caused diseases are a critical, emerging public health problem worldwide. Flaviviridae infections usually cause severe, acute or chronic diseases, such as liver damage and liver cancer resulting from a hepatitis C virus (HCV) infection Continue reading

Obstacle Recognition based on Machine Learning for On-Chip LiDAR Sensors in a Cyber-Physical System

ABSTRACT

Collision avoidance is an important feature in advanced driver-assistance systems, aimed at providing correct, timely and reliable warnings before an imminent collision (with objects, vehicles, pedestrians, etc.). The obstacle recognition library is Continue reading

Grid Synchronization of a Seven-Phase Wind Electric Generator using d-q PLL

ABSTRACT

The evolving multiphase induction generators (MPIGs) with more than three phases are receiving prominence in high power generation systems. This paper aims at the development of a comprehensive model of the wind turbine driven Continue reading

Control Strategy for a Grid-Connected Inverter under Unbalanced Network Conditions—A Disturbance Observer-based Decoupled Current Approach

ABSTRACT

This paper proposes a new approach on the novel current control strategy for grid-tied voltage-source inverters (VSIs) with circumstances of asymmetrical voltage conditions. A standard grid-connected inverter (GCI) allows the degree of freedom to Continue reading

Modified Synchronous Reference Frame based Shunt Active Power Filter with Fuzzy Logic Control Pulse Width Modulation Inverter

ABSTRACT

Harmonic distortion in power networks has greatly reduced power quality and this affects system stability. In order to mitigate this power quality issue, the shunt active power filter (SAPF) has been widely applied and it is proven to be the best solution to Continue reading

A Refined Self-Tuning Filter-based Instantaneous Power Theory Algorithm for Indirect Current Controlled Three-Level Inverter-Based Shunt Active Power Filters under Non-sinusoidal Source Voltage Conditions

ABSTRACT

In this paper, a refined reference current generation algorithm based on instantaneous power (pq) theory is proposed, for operation of an indirect current controlled (ICC) three-level neutral-point diode clamped (NPC) inverter-based shunt active power filter Continue reading

A Tactile Sensor Network System Using a Multiple Sensor Platform with a Dedicated CMOS-LSI for Robot Applications

ABSTRACT

Robot tactile sensation can enhance human–robot communication in terms of safety, reliability and accuracy. The final goal of our project is to widely cover a robot body with a large number of tactile sensors, which has significant advantages such as accurate Continue reading