Testing plays a very important role for assuring the quality of developed software. In a modern vehicle, more and more of the functionality is controlled by software and the complexity of Continue reading
Get Latest Final Year ECE/EEE Projects in your Email
Tag: Low Cost
Growth of Zinc Oxide Nanoparticles on Top of Polymers and Organic Small Molecules as a Transparent Cathode in Tandem Photovoltaic Device
Organic solar cells have caught considerable attention in the past few years due to their potential for providing environmentally safe, flexible, lightweight, inexpensive, and roll-to-roll feasible production Continue reading
Short-Circuit Contributions from Fully-Rated Converter Wind Turbines: Modeling and Simulation of Steady-State Short-Circuit Contributions from FRC Wind Turbines in Offshore Wind Power Plants
In recent years there has been an increase in wind power plants installed out at sea. The generated power of wind turbine generators (WTGs) are collected through numerous cables into a single hub, the offshore platform. Subsequently, this Continue reading
Energy Efficient LTE Site Operation: With Antenna Muting and Dynamic Psi-omni
To allow access to the network at all times a base station has to continuously stay active. While being active, a base station does not usually transmit data constantly. Typically, the base stations either send out lots of data or Continue reading
Investigation of Using Injection-Locked Fabry–Pérot Laser Diode With 10% Front-Facet Reflectivity for Short-Reach to Long-Reach Upstream PON Access
In this paper, we propose and investigate an injection-locked Fabry-Pérot laser diode (FP-LD) with 10% front-facet reflectivity by using Continue reading
Water Fun at Exploration Station
EXECUTIVE SUMMARY
This report documents the design and fabrication processes involved for the creation of an interactive science exhibit for the Grover Beach Exploration Station. This is a student – led senior project advised by Sarah Harding, professor of mechanical Continue reading
Miniatured Inertial Motion and Position Tracking and Visualization Systems Using Android Wear Platform
ABSTRACT
In this thesis, we have designed and developed a motion tracking and visualization system using the latest motion tracking sensory technologies. It is one of the enabling technologies for our novel visual – inertial odometer and human Continue reading
Design and Implementation of Comparator for Sigma Delta Modulator
Comparator is the main building block in an ADC architecture. Main purpose of the comparator is to compare a signal with a reference signal and produce an output depending on whether Continue reading
Optimized Tuning of Parameters for HVDC Dynamic Performance Studies
HVDC (High Voltage Direct Current) is used all over the world for transmission of electric power due to lower losses compared to traditional HVAC (High Voltage Alternating Current). However, the procedure of Continue reading
Automated Orchestra for Industrial Automation on Virtualized Multicore Environment
Industrial control systems are applied in many areas e.g., motion control for industrial robotics, process control of large plants such as in the area of oil and gas, and in Continue reading
M-PSK and M-QAM Modulation/Demodulation of UWB Signal Using Six-Port Correlator
Nowadays high speed and high data rate communication are highly demanded. Consequently, wideband and high frequency transmitter and receivers should be designed. New transmitters and receivers should also have low Continue reading